ActionTec MI424-WR User Manual page 152

Chapter 10 Troubleshooting
Are the Router's Ethernet ports auto-sensing?
Yes. Either a straight-through or crossover Ethernet cable can be used.
Can I use an 802.11b wireless card to connect to the Router?
Yes, the Router can interface with . b cards or . g cards. The . g
802 11 802 11 802 11
standard is backward compatible with the . b standard. The Router can be
802 11
setup to handle just "g" wireless cards, just "b" wireless cards, or both.
Can my wireless signal pass through floors, walls, and glass?
The physical environment surrounding the Router can have a varying effect on
signal strength and quality. The more dense the object (a concrete wall com-
pared to a plaster wall, for example), the greater the interference. Concrete or
metal-reinforced structures will experience a higher degree of signal loss than
those made of wood, plaster, or glass.
How do I find out what IP address my computer is using?
Windows 95, 98, 98SE, and Me - Select Start, Run, and type "winipcfg." Press Enter.
When the "Winipcfg" window appears, ensure your network device is selected.
Windows NT, 2000, and XP - Select Start, Run and type "cmd." Press Enter. When
the command screen appears, type "ipconfig" and press Enter.
My computer cannot connect to the Internet via MoCA. What should I do?
First, check the connection, and make sure all cables are connected correctly.
Then make sure the is still connected, and check the Ethernet connection
NIM
to the from the computer. A computer cannot be connected directly via a
NIM
o cable; it must go through a to connect. The converts the o
M CA NIM NIM M CA
signal to an Ethernet signal the computer can understand.
I used DHCP to configure my network. Do I need to restart my computer to
refresh my IP address?
No. Follow these steps to refresh the address:
IP
Windows 95, 98, 98SE, and Me - Select Start, Run, type "winipcfg," and press
Enter. Ensure the Ethernet adapter is selected in the device box. Press the
Release_all button, then press the Renew_all button.
Windows NT 4.0 and 2000 - Select Start, Run, type "cmd," and press Enter. At the
DOS prompt, type "ipconfig /release," then type "ipconfig /renew."
Windows XP - Unplug the Ethernet cable or wireless card and plug it back in.
149