Related Manuals for Fisher-Price N3216
Summary of Contents for Fisher-Price N3216
- Page 1 N3216 WARNING IMPORTANT! KEEP INSTRUCTIONS FOR FUTURE REFERENCE. www.fisher-price.com.au...
- Page 2 Important! WARNING To prevent strangulation with power cord, never place transmitter within reach of child. CAUTION This product cannot replace responsible adult supervision.
- Page 3 • For proper setup and use, please read these instructions. • Please keep this instruction sheet for future reference, as it contains important information. • Transmitter operates on AC current. • Receivers operate on AC current (use enclosed AC adaptors) or six “AAA” (LR03) alkaline batteries (batteries not included). • Adult assembly is required. • Tool needed for battery installation: Phillips screwdriver (not included). • This product is not intended to be used as a medical monitor and its use should not replace adult supervision. • Test sound reception of receiver(s) before first-time use and whenever you change location of transmitter. • To prevent entanglement: - Never place transmitter in a crib or playpen. Keep transmitter and receiver(s) out of baby’s reach. - Never use extension cords with the AC adaptors. • Never use transmitter or receiver(s) near water (ie.: bathtub, sink, laundry tub or wet basement, etc.). • Always use transmitter and receiver(s) where there is adequate ventilation. To prevent overheating, keep transmitter and receiver(s) away from heat sources such as radiators, heat registers, direct sunlight, stoves, amplifiers, or other appliances which produce heat. • Fisher-Price does not recommend the use of two monitors in one house. ® • Always remember that you are using public airwaves when using your monitor. Conversations, even from rooms near transmitter, may broadcast to other nursery monitors, radios, cordless telephones, or scanners outside your home. To protect privacy of your home, always turn transmitter off when not in use. Carrier Frequency: 40 Mhz Field Strength: 73.4dBuV/m at 3m • Product features and decoration may vary from photos. • Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities (Europe only). AUSTRALIA Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia. Consumer Advisory Service 1300 135 312. NEW ZEALAND 16-18 William Pickering Drive, Albany 1331, Auckland. Important!
- Page 4 Features...
- Page 5 Transmitter Power Indicator Microphone Power Button Night Light – press to turn on a soft glow. Channel Switch Receiver Speaker On/Off/Volume Dial – Turns power on. Set volume to a comfortable level. Clip - (backside of receiver). Fasten to your clothes to stay in touch with baby around the house or yard. Sound Lights - let you see baby’s sounds. Power/Low Battery Indicator Channel Switch Features...
- Page 6 Assembly Antenna Antenna Antenna Antenna • Fit each antenna into the socket in the receiver and the transmitter. Turn the antennas to secure in place. IMPORTANT! This product is designed to operate properly with the antennas provided. To reduce the chance of potential radio interference to other users, assemble and use only the antennas provided.
- Page 7 Receiver Battery Installation (Optional) Battery Compartment Door Battery Compartment Door • Locate battery compartment door on back of receiver. • Loosen screws in battery compartment door with a Phillips screwdriver. Remove battery compartment door. • Insert three “AAA” (LR03) alkaline batteries into the battery compartment. • Replace battery compartment door. Tighten screws with a Phillips screwdriver. Battery Safety Information In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Insert batteries as indicated inside the battery compartment. • Remove batteries during long periods of non-use. Always remove exhausted batteries from the product. Dispose of batteries safely. Do not dispose of this product in a fire. The batteries inside may explode or leak. • Never short-circuit the battery terminals. • Use only batteries of the same or equivalent type as recommended. • Do not charge non-rechargeable batteries. • Remove rechargeable batteries from the product before charging. • If removeable, rechargeable batteries are used, they are only to be charged under adult supervision. "AAA" (LR03) 1.5V x 3...
- Page 8 Testing Sound Reception Test transmitter transmission and receiver reception each time you change location of use. Power Button Power Button • Place transmitter in room in which you intend to use it. • Press transmitter power button to turn power on. Power indicator lights. • Set transmitter channel switch to same channel as receiver. Turn on a radio.
- Page 9 Testing Sound Reception Power/Low Battery Power/Low Battery Indicator Indicator • Place a receiver in rooms in which you intend to use each. • Turn on/off/volume dial to turn power on. Power/low battery indicator lights. Adjust receiver location for best reception. Hint: If battery power is low, the power/low battery indicator turns orange. Replace batteries with three, new alkaline “AAA” (LR03) batteries or use AC adaptor for power source. On/Off/Volume Dial On/Off/Volume Dial...
- Page 10 Testing Sound Reception Adjust Channel • Sound lights turn on when sound is received by a receiver. - One or two lights for shallow sounds - Three or more lights for louder sounds. • If you experience interference (buzzing or static, etc.) while using one channel setting, switch all units to other channel. Selecting a channel is usually a one time adjustment. Hint: You will see all five sound lights: - If you turn receiver power on before transmitter power. You will also hear static noise. Turn volume down and turn transmitter power on. - If the receiver is too far away from the transmitter.
-
Page 11: Setup And Use
Setup & Use IMPORTANT! Test sound reception of this monitor before first time use and whenever you change location of transmitter (see page 8). Adjust Channel • Set transmitter channel switch to same channel as receiver. - Page 12 Setup & Use • Place transmitter in same room with child. Point microphone directly toward crib/cot or play area. • Unwrap and fully extend power cord for best transmission. Plug power cord into wall outlet. • Use the power cord only in a wall outlet. Do not plug the power cord into a ceiling light. • Press transmitter power button to turn power on. • Press night light on transmitter for a soft, glowing light. (Press again to turn off night light.)
- Page 13 • Place receiver where you will see or hear it. • Unwrap and fully extend AC adaptor cord for best reception. Insert AC adaptor jack into receiver socket and plug into wall outlet. Note: To use batteries as a power source, refer to instructions on page 7. • Rotate receiver on/off/volume dial to turn power on. Power/low battery indicator lights. Rotate on/off/volume dial to adjust volume. Setup & Use...
- Page 14 Setup & Use • Clip to your clothes to stay in touch with baby around your house or yard. Hint: Under permitting conditions, the receiver receives sounds up to 122 meters away from baby!
-
Page 15: Problems And Solutions
Receiver power/low battery indicator does not light Receiver power/low battery indicator turns orange Transmitter power indicator does not light You can hear conversations or sounds from other homes Hint: If, after checking all of these solutions, you believe that your transmitter power cord or AC adaptor are damaged, please contact Fisher-Price Receiver is out of range of transmitter. Move receiver closer to transmitter. Note: Range varies depending on surrounding conditions such as noise levels, physical obstructions and signal interference. Transmitter power is off. Turn transmitter power on. Channel switches are on different channels. Make sure channel switches on both transmitter and receiver are set to same channel. Loose power cord connection and transmitter power is off. Check transmitter power cord plug-to-outlet connection. No power to wall outlet and transmitter power is off. Make sure light switch that controls power flow to wall outlet is on. -
Page 16: One (1) Year Limited Warranty
Mattel Australia Pty., Ltd., (658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia) warrants to the original owner that this product is free from all defects in material and workmanship when used under normal conditions for a period of one (1) year from the date of purchase. Should the product fail to perform properly, we will repair replace it at our option, free of charge. Purchaser is responsible for shipping the product to the Fisher-Price Product Service Department at the address indicated above and for all associated freight and insurance costs. Fisher-Price Inc., will bear the cost of shipping the repaired or replacement item to you. The warranty is void if the owner repairs or modifies the product. The is warranty excludes any liability other than that expressly stated above, including, but not limited to, any incidental or consequential damages. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH MAY VARY FROM STATE TO STATE. Consumer Advisory Service phone numbers are as follows: Australia 1300 135 312 New Zealand 0800 174 063 Excess dirt in transmitter microphone will hamper transmission of sound. Clean outer surface of transmitter and receiver with a cloth lightly dampened with a mild cleaning solution. Never immerse transmitter, receivers or AC adaptors. Fisher-Price, Inc., a subsidiary of Mattel, Inc.,/une filiale de Mattel, Inc., East Aurora, New York 14052, U.S.A./É. -U. ® and ™ designate U.S. trademarks of Mattel, Inc./ ® et ™ désignent des marques de Mattel, Inc. aux É. -U. PRINTED IN CHINA/IMPRIMÉ EN CHINE Care ©2008 Mattel, Inc. All Rights Reserved/Tous droits réservés. N3216pr-0729...