Table of Contents
Advertisement
Assembly
Tool
Rounded Side
12
• Attach a lock nut, rounded side facing out, onto one end of a
seat back wire.
• Tighten the lock nut by using the assembly tool. Turn the tool
clockwise to tighten the lock nut.
• Repeat this procedure to attach the other lock nut to the other
end of the seat back wire.
• Please throw the assembly tool away after completing this
assembly step.
Assembly
13
• Insert the ends of the seat tubes into the holes in the hubs.
• Push the seat tubes in until you hear a "snap" (for each).
• Push down on the seat to be sure the seat is secured in both
frame hubs.
Lock Nut – 2
14
• Insert a #6 x 3.18 cm screw into each frame hub and tighten.
• Again, push down on the seat to be sure the seat is secured to
both frame hubs.
7
Hubs
Seat Tubes
#6 x 3.18 cm Screw – 2
Advertisement
Table of Contents
