Mesa/Boogie GRID SLAMMER Owner's Manual page 2

it is fully charged and functional. Carbon Zinc, Alkaline or
AC POWER:
This standard female DC Receptacle on
even Nickel Cadmium Rechargeable type batteries are all
the pedal is the External Power Supply Jack and it accepts
acceptable replacements. Some pedal aficionados prefer
the male plug from a standard 9-Volt "wall-wart" AC power
the "sweetness" they claim to hear from standard Carbon
supply. When installing your unit into a pedal board utilizing
Zinc type batteries, but you will have to decide what type
a universal power supply (multi-output pedal board power
best serves your needs.
supplies), connect the external power source here. The
internal battery is automatically disconnected by a switch-
ing element in the External DC Receptacle on the pedal.
SPECIFICATIONS:
However, if you know you will not be using battery power
• Dimensions (W/D/H): 2.87" x 4.77" x 2.28" (73mm x
for an extended period – for example, if you are mounting
122mm x 58mm)
the unit to your pedal board permanently - it is wise to re-
move the battery to avoid possible damage from long-term
• Weight: 0.731lbs (332g) with battery, 0.631lbs (287g)
battery corrosion.
without battery
• True Bypass Switching
INTERNAL BATTERY:
This unit can operate on either a
• Battery Type: 9VDC (one)
9-Volt battery or a standard 9-Volt "wall-wart" power supply.
The unit is shipped from the Factory with a long-life 9-Volt
• Power Consumption (Current Draw): 9VDC/15mA
Battery to facilitate easier trial demonstration in a music
• AC Adapter (Optional): Power Jack 2.1mm x 5.5mm,
store environment.
9VDC with Negative Center (Regulated Recommend-
ed)
NOTE: The internal battery is switched to an "ON" state
(drawing voltage) by a switching element in the INPUT jack.
• Input Impedance: 1M Ohm (500k Ohm minimum)
Disconnect the cable from the ¼" INPUT jack whenever the
unit is not in use to prolong battery life.
• Output Impedance: 10k Ohm
BATTERY REPLACEMENT:
To access the 9-Volt bat-
tery for inspection, replacement or removal; make sure
the External Power Jack is disconnected, remove the four
Phillips-head screws from the four corners of the bottom lid
and remove it. Note the orientation/direction of the battery
and terminals and replace it in the same position.
NOTE: Any type of 9-Volt battery will work in this device if
SAMPLE SETTINGS:
SUBTLE CLIP BLUES SOLO
LEVEL TONE LEVEL
GAIN
SMOOTH SUSTAIN GRID SLAM
LEVEL TONE GAIN LEVEL
SAMPLE SETTINGS: USER SETTINGS:
TONE LEVEL TONE
GAIN
TONE GAIN LEVEL TONE
®
GAIN
®
GAIN