Instrument Cluster - Mazda 3 Smart Start Manual

Hide thumbs Also See for 3:
Table of Contents

Advertisement

Instrument Cluster

DAShBOARD
iLLUMiNATiON
gLOSSARY Of WARNiNg AND iNDiCATOR LighTS
NOTE:
See Owner's Manual for more details and explanations.
Check fuel Cap
Low Engine Oil Pressure
Dynamic Stability Control
(DSC)/Traction Control
Off
System (TCS) Off
indicator Light
DSC OFF switch pushed and
TCS/DSC turned off.
Check Engine Light
Security indicator Light
Lights On (Exterior)
Power Steering Malfunction
ABS (Antilock Brake
System) Malfunction
Air Bag/front Seat Belt
Pretensioner System
Malfunction
1
• Rotate the knob to adjust the brightness of the instrument cluster and other dashboard illuminations.
Vehicles with Multi-Information Display:
The instrument cluster has a dimmer function that can be cancelled to make the illumination brighter
during the day when the headlights are on. If the illumination is too dim during the day, press the knob,
9
or if the illumination does not dim when turning on the headlights at night, press the knob. When
dimmed, rotate the knob to adjust the brightness of the illumination.
927628_12a_Mazda3_SSG_070111.indd 10-11
fUEL
TAChOMETER
gAUgE
1
Low fuel Level
Turn Signals/hazard
Warning indicator Lights
headlight high Beams On
Automatic Transaxle
Warning Light
Cruise Main indicator Light
On (
AMBER
)/Cruise Set
indicator Light On (
Shift Position indicator Light
Malfunction Warning Light
Charging System Malfunction
Door/Liftgate Ajar
AfS
Adaptive front Lighting
Off
System (AfS) Off
ODOMETER/
ShifT LEVER
TRiP METER
POSiTiON iNDiCATOR
Tire Pressure
Monitoring System
(TPMS
On/Warning Beep: Low tire
pressure in one or more tires.
Flashing: TPMS Malfunction
Seat Belt
Unbuckled/Malfunction
BSM
BSM Off
Off
(Blind Spot Monitoring)
KEY Warning Light
KEY indicator Light
gREEN
)
Brake Warning Light
Parking brake on/low brake
fluid/malfunction
Traction Control System
(TCS)/Dynamic Stability
Control (DSC)
On: TCS/DSC malfunction
Flashing: TCS/DSC operating
2
• Push to toggle between trip meter (A & B).
• When a trip meter is selected, push and hold
to reset to zero.
NOTE:
Low ambient temperature and/or high altitude causes tire pressures to drop
and may turn the TPMS warning light on. If the warning light comes on, check the tire
pressure and fill the tires as soon as possible, preferably before moving the vehicle
and warming up the tires. Tire pressure should be checked when the tires are cold.
SPEEDOMETER
Low Washer fluid Level
Warning Light
) Warning Light
ENgiNE COOLANT TEMP LighTS
Since this vehicle does not use an engine
coolant temperature gauge, red and blue
engine coolant temperature lights are used
to indicate high and low coolant temperature.
Red Coolant Temp Light
flashing: Engine is starting to run hot.
Drive slowly to reduce engine load.
On: Engine is overheating. Safely pull
RED
over to the side of the road and turn the
engine off.
gREEN
Refer to the Owner's Manual for
more information.
Blue Coolant Temp Light
On: Engine coolant is cold and no warm
air is available for heater/defroster.
Off: Engine coolant is warm and warm
air is available for heater/defroster.
The light may stay on for a few minutes
after start-up when the engine is cold,
but the vehicle can be driven with the
light on or off.
www.MazdaUSA.com
TRiP METER
SELECTOR
2
10
7/1/11 2:54 PM

Advertisement

Table of Contents
loading

This manual is also suitable for:

2012 mazda3

Table of Contents