Mazda Tribute Quick Tips page 6

Quick Tips
Dual power
mirrors
To adjust left/right
mirror: Rotate control
switch (1) left/right,
tilt in direction
of desired mirror
1
movement
Tip: To lock mirrors in
place, move control switch
to center position
Child-safety seat
To install in rear outboard
passenger seat positions using
dual-locking mode retractor safety
belts; see Owner's Manual for
proper installation and seat tether
and LATCH system instructions
Passenger airbag sensing
system, see Getting Started
Always check the Owner's Manual for more operating information and safety features
Mazda
2
AUTO
3
4
Power windows
Operate with ignition in
ON position
All windows may be controlled
from driver's door; each passenger
door has a separate switch
2. Driver's window
One-touch-down: Press rear
of switch firmly and release,
window goes down all
the way; tap switch again
to stop; press and hold for
WARNINGS: Use age
appropriate child restraints,
see Owner's Manual and
state or province laws
Never place rear-facing
infant-safety seat in front
passenger seat in front
of any air bag, an infant
is in serious danger of
being injured or killed
If you must install a
forward-facing child-safety
seat in the front seating
position, move vehicle seat
as far back as possible
It is strongly recommended
that you install front facing
child-safety seats in rear
seating area
*Denotes optional equipment
2005 Tribute
normal operation; press and
hold front of switch to close
3. Passenger window
switches
Press rear/front of switch
to open/close
4. Power window lockout
switch
Press right side of switch:
only driver's switches control
windows; press left side of
switch and passenger controls
function again
Tip: Power windows and
moonroof can be operated
for 10 minutes after ignition
key is turned off and with
doors closed, opening door
will completely cancel this
function
Rear child-safety seat
anchors
Anchors located on rear seat
cushion for securing child-safety
seat (see Owner's Manual)
Dual locking mode lap/
shoulder belt retractor
(front passenger and all
rear belts only)
Emergency locking mode: Belt
locks only on hard braking/
cornering or impacts of about
5 mph or higher
Automatic locking mode must
be used when installing child-
safety seat
To activate: Pull webbing fully out
of retractor until click is heard;
belt will only tighten
To disengage: Unbuckle belt
and allow webbing to retract
fully; for complete details
see Owner's Manual
page 10
page 11