Using Voice Control - Mazda USA_NAVI Manual

USA_NAVI_EN.book 16 ページ ２０１２年９月１１日 火曜日 午前１０時３６分

Using voice control

Voice control is switched on by default if it is supported by your chosen language.
The following example shows how to use voice control to plan a journey to your Home
address:
1. Tap the microphone button in the Driving view to turn on the microphone.
You see a screen with examples of commands you can say.
Tap Help in the Main menu then tap Product manuals followed by What can I say to see
a full list of commands you can say.
When you hear "Say a command" followed by a tone, say a command of your choice. For
example, you can say "Drive home". Your Navigation Device is only ready to listen after
your hear the tone.
While you are speaking the microphone monitor shows how well the device can hear your
voice:
For some phrases, your Navigation Device repeats what you say and asks for confirmation.
Tip: For the best recognition of what you say, speak normally without trying to
articulate words in an unnatural way. If there is excessive road noise, for example, you
may need to speak in the direction of the microphone.
2. If the command is correct, say "Yes."
If the command is incorrect, say "No" and repeat the command after you hear the prompt
and tone again.
Your Navigation Device plans a route from your current location to your destination.
Tip: To stop your Navigation Device from listening out for further commands, say
"Cancel". To go back one step, say "Back".
A green bar means the device can hear your voice.
A red bar means your voice is too loud for the device to
recognise individual words.
A grey bar means your voice is too quiet for the device to
recognise individual words.
16