Whirlpool 3395339 Installation Instructions Manual page 9

Coin-operated stacked dryers
Table of Contents

Advertisement

Remove
the red caps from the gas
pipes.
11.
Connect
gas supply to each dryer.
Use pipe-joint
compound
resistant to
the action
of Natural
and L.P. gas for
gas connections.
12.
Open the shutoff valves in the gas
supply lines.
Fire Hazard
Do Not use an open flame to test
for leaks from gas connections.
Checking
for leaks with a flame
may result in a fire or explosion.
13.
Use a brush and liquid detergent
to
test all gas connections
for leaks.
Bubbles around
connections
will
indicate
a leak. If a leak appears,
shut off gas valve controls
and adjust
connections.
Then check
connections
again.
NEVER TEST FOR
GAS LEAKS WITH A FLAME. Close the
access
panels.
All connections
must be wrench-
tightened.
8 00
0 8 00
14 w
Plug power
supply cords into
grounded
outlets. Turn on electrical
power
supply.
Floor Damage
Slide dryers onto cardboard
or
hardboard
before
moving
across
floor.
Failure to do so may result in
damage
to floor covering.
Move unit to its permanent
location.
15.
Turn one dryer on to remove
air from
the gas supply line. Using a full heat
cycle
(not the air cycle),
let the dryer
run for at least five minutes,
If the
burner does not ignite and you can
feel no heat inside the dryer, shut off
the dryer for five minutes. Check
that
all supply valve controls
are in 'ON"
position and that the power supply
cord is plugged
in. Repeat
the five-
minute test.
16.
Check
levelness
of dryers by placing
a carpenter's
level on top of the
dryers or collar, first side to side, then
front to back.
If dryer is not level,
adjust the front legs up or down.
Make the final check
with the level.
17
n
TO exhaust
the dryers, see
"Exhaust
requirements"
and "Exhaust
duct connection,"
pages
5 and 6.
Personal Injury Hazard
To prevent
tipping,
tether bracket
must be secured
to wall studs or
concrete
wall.
Failure to do so could
result in
personal
injury.
Tether bracket,
located
at
rear of the top dryer.
w
Attach
both ends of tether located
at
the rear of the top dryer to a secured
2x4.
Page
9

Advertisement

Table of Contents
loading

Table of Contents