Table of Contents
Advertisement
1
25 Amp Fuse
GOOD FUSE
"BLOWN" FUSE
• If you are charging the battery for the first time, insert a
25 amp fuse into the battery.
Note: The top of the fuse will not be flush with the top of
the battery when properly installed.
• If you are recharging your battery, make sure the 25 amp
fuse already installed in the battery is in good condition.
Remove the fuse from the battery and look at it to make
sure it is not blown. Replace a blown fuse with a new
Power Wheels
®
25 amp fuse.
2
Charger Connector
• Squeeze the connector tabs on the charger connector
and plug it into the battery connector.
IMPORTANT! If you are recharging your battery, you will
first need to remove the pretend engine cover and discon-
nect the battery connector from the motor harness con-
nector under the hood.
Battery Charging
Battery Connector
3
• Plug the charger into a standard wall outlet.
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is "ON".
• Before first-time use, charge the battery for at least
18 hours. Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each
use of your vehicle. Do not charge the battery longer
than 30 hours.
• Once the battery is charged, disconnect the charger
connector from the battery connector. Unplug the
charger from the wall outlet. The battery is now
ready to be installed in your vehicle. Please see the
Battery Installation section on page 16 for detailed
instructions on installing your battery.
8
Advertisement
Table of Contents
