Advertisement
Quick Links
QUICK START GUIDE - BELLA™ PELLET STOVE
1
PURCHASING THE CORRECT FUEL FOR THE STOVE
The Bella™ pellet stove has been designed to burn wood pellets. We recommend burning
Premium Grade wood pellet fuel manufactured by companies who are members of the Pellet
Fuels Institute (PFI). Although similar in appearance to those made of wood, other pelletized
fuels such as wheat, barley, cherry pits, etc. will adversely affect the performance of the stove
and may compromise safety and void warranty.
RECOMMENDED FUEL
•
PFI APPROVED
•
PREMIUM GRADE
•
LESS THAN 1% ASH CONTENT
•
LESS THAN 300 PPM CHLORIDES
WARNING
Before you set up or operate your stove, review all safety, installation,
and operation instructions in your "Installation and Operation Manual."
USING THIS GUIDE
This guide contains 5 easy steps to help you learn more about using
your new Bella™ pellet stove. Detailed operating and cleaning instruc-
tions are located in the "Installation and Operation Manual."
INCORRECT FUEL
•
MOISTURE DAMAGE
•
EXCESSIVE SAWDUST
•
HIGH CHLORIDE OR
ASH CONTENT
•
OVERSIZED PELLETS
(LONGER THAN 1-1/2")
•
COMMERCIAL GRADE
•
ECONOMY GRADE
PFI LOGO
•
WHEAT PELLETS
•
BARLEY PELLETS
•
BARK PELLETS
Advertisement
Related Manuals for Lennox Hearth Products BELLA
Summary of Contents for Lennox Hearth Products BELLA
- Page 1 “Installation and Operation Manual.” PURCHASING THE CORRECT FUEL FOR THE STOVE The Bella™ pellet stove has been designed to burn wood pellets. We recommend burning Premium Grade wood pellet fuel manufactured by companies who are members of the Pellet Fuels Institute (PFI).
-
Page 2: Manual Operation
FAN SPEED SENSORS MANUAL OPERATION* DIAGNOSTIC BELLA CONTROL BOARD THERMOSTAT STARTING THE BELLA™ PELLET STOVE DC AUGER WARNING Hopper lid must Fill the hopper with pellets DO NOT REMOVE COVER be closed during DIAGNOSTIC BELLA CONTROL BOARD HIGH VOLTAGE INSIDE... -
Page 3: Damper Adjustment
DAMPER ADJUSTMENT The Bella™ pellet stove is equipped with a damper which is used to fine tune combustion. Although every unit is test burned and calibrated at the factory, periodic adjustment may be necessary at times to compensate for vari- ables such as fuel, venting, climate, altitude, and maintenance intervals. - Page 4 CLEANING AND MAINTENANCE SCHEDULE (CONTINUED) In addition to the regular maintenance procedures described below, the “Installation and Operation Manual” out- lines yearly service that should be performed by a qualified technician. Burn Pot Heat Exchanger The burn pot should be checked Keeping the heat exchanger for clinkers prior to operating tubes clean will maximize the...