Seagate MEDALIST 1270 Installation Manual page 18

16 Medalist 1270 Installation Guide, July 1995
of conventional memory are not free when these virus
programs inspect conventional memory, they assume
a virus is present and clean and restore the memory.
If this happens, information about the EZ-Drive in-
stalled drive is destroyed, and the drive cannot be
identified by the computer. Do not use these programs.
Note. The Seagate version of EZ-Drive cannot install a non-Sea-
gate drive without a Seagate drive present.
1. Boot your computer with the Seagate software diskette with
EZ-Drive. This is a precaution to ensure that the EZ-Drive
installation does not conflict with any terminate-and-stay resi-
dent (TSR) programs that may be in memory.
2. Type ez and press
ENTER
3. Disregard the Notice dialog box. The EZ-Drive software is
authorized for installation only with the drive on which it is
shipped. Press to continue.
ENTER
4. Locate the bottom box on the screen. The model number of
each drive EZ-Drive identifies is listed in this box. If a drive you
have installed is not listed or the drive order (Drive 0 is the
master, Drive 1 is the slave) is incorrect or there is a drive not
identified message, make sure the master and slave jumpers
are set correctly on the drives and the I/O and power cables
are properly connected.
Note. Other troubleshooting tips are available in the Information
Help menu.
Caution. Turn off your computer before resetting the jumpers or
removing the cables.
5. If the drives are correctly identified, select Fully Automatic
Installation in the Main menu dialog box above. This creates
a single partition and formats the drive.
If you are installing the drive as Drive C, EZ-Drive automat-
ically writes the system files to the drive to make it bootable.
.