Fisher-Price HARLEY-DAVIDSON Motorcycle 74370 Owner's Manual & Assembly Instructions page 13

74370a-0920.qrk 5/21/01 2:06 PM Page 13
8
Peg
Stabilizer
Wheel
Vehicle Frame
(Right Side)
• Separate the exhaust set pieces. Note the R (right side)
and L (left side) markings on the inside of each piece.
• Fit the inner half of the right exhaust pipe (R) over the
stabilizer wheel on the right side of the vehicle. Make
sure the peg on the inner exhaust pipe fits into the
hole in the vehicle body.
9
Right Exhaust
Pipe - Inner Half
*
Vehicle
Frame
Hint: Use a long-shafted screwdriver to complete this
assembly step.
• Align the holes in the inner half of the right exhaust pipe
with the holes in the vehicle frame.
• Insert four #8 x 3 / " screws through the inner half of the
4
right exhaust pipe and into the vehicle frame.
Assembly
Right Exhaust
Pipe - Inner Half
Vehicle
Body Hole
IMPORTANT! The screw marked with an asterisk * in
step 9 illustration must go through the hole in the inner
half of the right exhaust pipe, the vehicle body and into
the vehicle frame. Make sure all the holes are properly
aligned and the screw goes through all three parts.
• Tighten the screws using a Phillips screwdriver.
Do not over-tighten.
10
Right Exhaust
Pipe - Outer Half
• Fit the outer half of the right exhaust pipe (R) to the
inner half of the right exhaust pipe.
11
Right
Exhaust
Pipe
• With the holes aligned, insert six #8 x
the two halves of the right exhaust pipe.
• Tighten the screws using a Phillips screwdriver. Do not
over-tighten.
• Repeat steps 8 through 11 to assemble the left exhaust
pipe (L) to the left side of the vehicle.
13
3 / "screws to join
4