Assembly - Fisher-Price HARLEY-DAVIDSON Motorcycle 74370 Owner's Manual & Assembly Instructions

74370a-0920.qrk 5/21/01 2:06 PM Page 11
F
Children can be harmed by small parts, sharp edges and sharp points
in the vehicle's unassembled state, or by electrical items. Care should be taken
in unpacking and assembly of the vehicle. Children should not handle parts,
1
Taillight
Cover
Taillight
• Position the taillight cover with the inside arrow
pointing upward.
• Fit the tail light cover on the back of the taillight.
• Insert two #8 x 1 / " screws through the holes in the
2
taillight cover. Tighten the screws with a Phillips
screwdriver. Do not over-tighten.
2
Taillight
#8 x 3 / " Screw
4
Vehicle Body
• Position the vehicle body upside down on a flat surface.
• Fit the taillight on the outside of the rear fender as
shown. Make sure the holes in the rear fender and
taillight are aligned.

Assembly

WARNING
including the battery, or help in assembly of the vehicle.
#8 x 1 / " Screw
2
#8 x 3 / " Screw
4
• Insert one #8 x 1 / " screw through the hole near the end
2
of the fender in the vehicle body and into the taillight.
• Insert two #8 x 3 / " screws through the remaining holes
4
in the vehicle body and into the taillight.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
3
Rectangular
Opening
Square
Opening
High Speed Hook-Up
• Pull firmly to separate the two black motor harness
connectors near the rear of the vehicle frame.
• Position the vehicle body on top of the vehicle frame.
• Fit each motor harness connector up through the
rectangular opening in the vehicle body, one at a time.
• Fit the two halves of the high speed hook-up con-
nector through the square opening near the front of the
vehicle body.
11
Vehicle
Body
Motor
Harness
Connectors
Rear of
Vehicle
Vehicle Frame