Table of Contents
Advertisement
Before you begin, take note!
• Please keep this manual for future reference, as it contains important
information.
• Adult assembly is required to install batteries.
• Tool needed for battery installation: Phillips screwdriver (not included).
• Requires four "AA" (LR6) alkaline batteries for operation (not included).
• Replace batteries when:
- Display on the screen becomes difficult to see.
- Toy functions erratically.
- Sounds become faint or there are no sounds at all.
• Use only the drawing stylus on the screen. Never use any other object,
such as a regular pen or pencil, on the screen. Markings from regular pens
or pencils cannot be removed and will damage the screen.
• Be sure to turn Pixter
(sold separately) into the software port. Turn Pixter power back on to play!
IMPORTANT! You must calibrate the stylus to the screen before
first-time use.
• Install four "AA" alkaline batteries. Turn Pixter power on. Wait until you see
the Home Screen.
• Turn Pixter over and locate the calibration hole.
• Insert, push and hold the stylus in the calibration hole. Turn Pixter over so that
you can see the screen. When you see two plus signs
from the calibration hole.
• First touch the upper right corner
• Then, touch the lower left corner
power off before inserting a software cartridge
®
with the tip of the stylus.
with the tip of the stylus.
3
remove the stylus
Advertisement
Table of Contents
