Korg Zore4 Owner's Manual page 20

Using the ZERO4 at the 192 kHz sampling rate
By starting up the ZERO4 in the special 192 kHz audio mode, you can use
it as a high-quality 24-bit/192 kHz 8-in/8-out audio interface.
Note: When using Mac OS X, the 192 kHz sampling rate is not
supported.
Starting up in 192 kHz audio mode
While holding down the KEEP button, turn on the power.
Note: If you start up in 192 kHz audio mode, you won't be able to
switch to other sampling rates (44.1 kHz, 48 kHz, 96 kHz).
If you want to switch to a different sampling rate, you must
turn off the power and then turn the power on again to start
up in the normal way.
Limitations in 192 kHz audio mode
The specifications are limited as follows when operating in the special 192
kHz mode.
• Number of channels: Four stereo channels (8-in/8-out)
• Channel EQ: Not available
• Channel effects, loop sampler, master effect: Not available
Controller operation when in 192 kHz audio mode
Channel Controller
INPUT SELECTOR
GAIN
FX TYPE
PAN
HI
MID
LO
TIME
MOD
FB
FX MIX
FX ON
MUTE
CUE
A
20
Operates normally
Operates normally
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
Operates normally
Operates normally
Operates normally
B
Operates normally
CH FADER
Operates normally
Master Controller
CH SELECT (SAMPLER/FX)
Not available
LOOP LENGTH
Not available
KEEP
Not available
LOOP PLAY
Not available
GATE PLAY
Not available
MASTER FX TYPE
Not available
X
Not available
Y
Not available
MASTER FX & SAMPLE MIX
Not available
CUE
Not available
BOOTH VOL
Operates normally
MASTER VOL
Operates normally
SPLIT
Operates normally
MONITOR BAL
Operates normally
MONITOR LEVEL
Operates normally
CROSSFADER
Operates normally
CROSSFADER CURVE
Operates normally
CROSSFADER REVERSE
Operates normally
CH FADER CURVE
Operates normally
CH FADER REVERSE
Operates normally
EQ SELECT
Not available