Page 2
Assembly LOWER RAMP • Fit the tabs on an upper ramp into the slots in a lower ramp. • Insert two screws into the upper ramp. Tighten the screws with a Phillips screwdriver. Do not over-tighten. • Repeat this procedure to build the other upper/lower ramp assembly. UPPER RAMP SUPPORT TOP “Snap”...
Page 3
Elevation Track Tips You can stack up support column assemblies to make a higher track layout. To properly support elevated tracks, always make sure you have support columns under track connections. • When using a curved track (not included) at the bottom of a ramp assembly, be sure to use a guardrail on the curve.
Page 4
Parts 6 Straight Tracks 4 Short Tracks 6 Support Tops 2 Upper Ramps 2 Lower Ramps 12 Support Columns G. 2 Guardrails H. #4 x ” Screw – 4 Please keep this instruction sheet for future reference, as it contains important information.