Specifying The Type Of External Midi Sound Module (Tone Name); Specifying The Midi Data Output Format For The General Memory Pistons (Tx Piston); Returning All Settings To The Factory-Set State (Factory Reset) - Roland Classic C-380 Owner's Manual

Other Settings
Specifying the Type of External MIDI Sound
Module (Tone Name)
When using an [USER/MIDI] coupler with an MX-200 or GM2-
compatible external MIDI sound module, you can make the sound
names of your MX-200 or GM2-compatible sound module appear in
the "USER/MIDI" screen.
* If you're using a MIDI sound module that does not support GM2,
choose the "OFF" setting.
Value Explanation
OFF Tone name will not show.
The screen will show the name of the MX-200's sound
MX200 if an MX-200 is connected as an external MIDI sound
module.
The screen will show the name of the GM2 sound if a
GM2 GM2-compatible sound module is connected as an
external MIDI sound module.
* This setting will return to "MX200" when you turn off the power, but
you can store the setting so that it will be remembered even after
the power is turned off. For details, refer to "Storing Your Settings
(Customize)" (p. 73).
Specifying the MIDI Data Output format for
the General Memory Pistons (Tx Piston)
When transmitting performance data via MIDI, you can specify the
type of MIDI data that will be transmitted when you press a general
memory [1]–[5] piston.
Value Explanation
OFF MIDI data will not be transmitted.
Data describing the details of the sounds that should
be produced when that piston is pressed will be
transmitted. If you're recording your performance into
a MIDI sequencer, this will ensure that the sounds are
STOP MAP reproduced accurately.
However, since a large amount of data is transmitted
when you press the piston, the sounding of the first
note-on after you press the piston may be delayed in
some cases.
Only program changes indicating the current memory
bank and the general memory piston that was pressed
will be transmitted.
If you're recording your performance into a MIDI
sequencer, the performance will not be accurately
reproduced unless the contents of the memory bank
PC used during the performance match the contents
during recording (for example, if you've saved the
settings to USB memory).
However, since a large amount of data will not be
transmitted when you press the piston, there will be no
significant delay in the first note-on after you press the
piston.
* This setting will return to "STOP MAP" when you turn off the power,
but you can store the setting so that it will be remembered even
after the power is turned off. For details, refer to "Storing Your
Settings (Customize)" (p. 73).
72
Returning all Settings to the
Factory-Set State (Factory Reset)
All settings stored in the organ can be reset to their factory-set
condition. This operation is called "Factory Reset."
Factory reset will cause all of the recorded songs, the general
memory pistons, and division memory pistons (C-380 only) to
return to their factory settings. Please copy your settings to
USB memory before you proceed.
➔ "Saving a Recorded Song" (p. 57)
➔ "Saving and Loading Memory Banks" (p. 62)
1.
From the main screen, press the [Select/Menu] knob.
2.
Turn the [Select/Menu] knob to select "11 Save/Load
(USB)."
fig.LCD012.eps
3.
Press the [Select/Menu] knob to access the "Save/Load
(USB)" screen.
4.
Turn the [Select/Menu] knob to select "Factory Reset."
fig.LCD061.eps
5.
Press the [Select/Menu] knob.
Confirmation screen will appear
fig.LCD962.eps
If you decide to cancel, press the [Value/Exit Menu] knob.