Fitting Unit - Rinnai RHFE-431FA Owner's Operation And Installation Manual

AIR INLET HOSE
Detail of Hose clip
Plastic tie
Inlet elbow
Inlet hose
When servicing unit replace plastic tie with new one.
(Available at local hardware store or contact local
distributor.)
LOCKING CLAMP SCREW CLAMP AND
INSULATION.
The following components can be fitted by reaching
down the rear of the appliance as it is positioned
against the wall.
1. Connect the flue outlet to the manifold by
extending the stainless steel sliding tube until it is
fully inserted into the manifold.
Sliding Tube
Slide
Do not extend flue tube
beyond red line.

FITTING UNIT

Manifold
Inlet hose
Hose clip
Manifold
– 22 –
2. Fit the locking clamp over connection between
sliding tube and manifold. Engage the hook and
rotate it until it snaps against the body of the clamp.
Manifold
Flue outlet
Sliding tube
Locking
clamp
3. Fit the screw clamp between the sliding tube and
the flue elbow. Secure with the 4mm screws
supplied. The flue outlet is now locked into position.
Flue Outlet tube screw
screw clamp
Flue Outlet
Flue elbow
sliding tube
4. Slide the insulation sleeve up to the flue
manifold, slip the securing clip over the sleeve as
shown.
Slide insulation sock
Flue outlet
Flue elbow
Sliding tube
Sock
Hook
Locking
Clamp
Locking clamp
Manifold
Fit clip
Slide to here