Before you begin, take note!
IMPORTANT! You must calibrate the stylus to the screen before
first-time use.
• Install four "AA" alkaline batteries. Turn Pixter® power on. Wait until you
see the Home Screen.
• Turn Pixter over and locate the calibration hole.
• Insert, push and hold the stylus in the calibration hole. Turn Pixter over
so that you can see the screen. When you see two plus signs
the stylus from the calibration hole.
• First touch the upper left corner
• Then, touch the lower right corner
™
with the tip of the stylus.
5
with the tip of the stylus.
remove