Sanitizing Solution; Sanitizing Procedure - Initial - Hoshizaki F-500BAF Instruction Manual

13) Turn on the power supply and allow the water system to drain for 5 minutes.
14) Turn off the power supply, then remove the top and front panels. Move the flush switch to
the "ICE" position, then replace the panels in their correct positions.
15) Open the icemaker water supply line shut-off valve, then turn on the power supply to
supply water to the reservoir.
16) After the gear motor starts, turn off the power supply. Remove the top and front panels,
then move the flush switch to the "FLUSH" position. Replace the panels in their correct
positions.
17) Turn on the power supply and allow the water system to drain for 5 minutes.
Note: If you do not sanitize the unit, go to step 14 in "III.A.5. Sanitizing
Procedure - Final."
18) Turn off the power supply, then close the icemaker water supply line shut-off valve.

3. Sanitizing Solution

For safety and maximum effectiveness, use the solution immediately after
dilution.
Dilute 2.5 fl. oz. (74 ml or 5 tbs) of a 5.25% sodium hypochlorite solution (chlorine
bleach) with 5 gal. (19 l) of warm water.

4. Sanitizing Procedure - Initial

1) Make sure the power supply is off and the icemaker water supply line shut-off valve
is closed. Remove the top and front panels, then move the power switch to the "OFF"
position.
2) In the storage bin, remove spout B and gasket B, then remove spout A and gasket A.
Next, remove the safety switch assembly from spout A.
3) Pour the sanitizing solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to overflow into the drain pan.
4) Remove the snap pin, shaft, actuator, and bin control bracket from the bin top cover.
5) Remove the sliding door.
6) Soak the sliding door, spouts, gaskets, packing, snap pin, shaft, actuator, and bin
control bracket in .25 gallons (1 l) of sanitizing solution for 10 minutes, then wipe them
down.
7) Rinse the parts thoroughly with clean water.
If the solution is left on these parts, they will rust.
8) Replace all parts in their correct positions.
9) Move the flush switch to the "ICE" position, then move the power switch to the "ON"
position. Replace the panels in their correct positions, then turn on the power supply.
Make ice using the solution until the icemaker stops making ice.
IMPORTANT
CAUTION
17