Grace Digital Audio AQSTR400W User Manual

Grace Digital Audio AQSTR400W User Manual

Floating wireless speaker system
Hide thumbs Also See for AQSTR400W:

Advertisement

Aqua Sounder
User Guide
AQSTR400W

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AQSTR400W and is the answer not in the manual?

Questions and answers

Summary of Contents for Grace Digital Audio AQSTR400W

  • Page 1 Aqua Sounder User Guide AQSTR400W...
  • Page 2: Inside The Package

    INTRODUCTION This Floating Wireless Speaker System uses the latest 900Mhz wireless technology to enable you to enjoy music outdoors in your swimming pool. It is simple to connect the portable transmitter to typical audio sources such as an i-Pod, Hi-Fi, CD/MP3 player or other audio source. INSIDE THE PACKAGE 1.
  • Page 3: Components Identification

    COMPONENTS IDENTIFICATION TRANSMITTER Power/Signal indicator (Green/Blue) SPEAKER...
  • Page 4: Installation

    INSTALLATION TRANSMITTER Connect the supplied AC power adapter to an electrical wall outlet. Plug the AC power adapter in the DC jack located on the rear of the transmitter. Or you can insert 4 X “AA” size ALKALINE batteries into the battery compartment at the bottom of the transmitter with correct polarity.
  • Page 5: Operation

    OPERATION 1. Turn on the transmitter. The LED will light up in Green. 2. Turn on the audio source (TV or audio component like an iPod) to which the transmitter is connected. The LED will change from Green to Blue. 3.
  • Page 6: Switching Off

    When there has water inside the speaker, simply open the speaker cover to release water out. Just use your finger tab to press the edge of speaker cover (as figure) and open the cover. After that, close the speaker cover with correct position.
  • Page 7: Troubleshooting

    TROUBLE SHOOTING NO SOUND Too much water retention inside the speaker grill. Turn the speaker over and gently shake it to let the water drain out. Ensure you have fresh alkaline batteries for both transmitter and receiver if the speaker’s and/or transmitter’s battery charge is too low, sound distortion will be heard.
  • Page 8: Technical Specifications

    TECHNICAL SPECIFICATIONS Transmission Mode UHF stereo Carrier Frequency 900 MHz Operation Voltage Transmitter, 4 X “AA” size Alkaline batteries (not included) or DC 6V 300mA adaptor (included) Speaker, 6 X “AA” size Alkaline batteries (not included) Frequency Response 40Hz – 12KHz Distortion 1.5% S/N Ratio...

Table of Contents