List Of Functions & Features - QSC CM16a Hardware Manual

Section 1:
Introduction- List of Functions & Features
FUNCTIONAL LISTING, BLOCK DIAGRAM & DETAILED DESCRIPTIONS
The CM16a performs remote control and monitoring of amplifiers. Below is a listing of the functions available for the supported QSC
amplifiers. The following two pages (Block Diagram part 1 & 2) illustrate the main functions of the CM16a. Following the diagram is a section
giving detailed explanations on each functional block that will aid in the use of the CM16a. Note that not all features may be supported
by the current revision level of software (consult software documentation for supported feature set). Where applicable, functions are
available on each individual audio channel.
CONTROL FUNCTIONS
Amplifier: Power (Standby/Operate Control)
CM16a:
MONITOR FUNCTIONS
Amplifier: Power Status
CM16a
SPECIAL FEATURES
DAC (digital-to-analog converter) that can be used for generating test signals
RS-232 Port for setting of network address information and system diagnostics
TFTP upgradeable firmware via Ethernet
8
Input Sensitivity Select
Signal Level Control
Signal Polarity Select
Contact Closure Output (switching of internal relay for control of external device)
Paralleling within DataPort Pair
Amplifier Model
Load Monitor (impedance)
Output Voltage
Output Power (real)
Headroom
Output Short
Input Level Meter
Audio Monitor Module (4 channel mono. mixer)
External Event Sensing (a logic-level or switch input)
Input Source Select (Normal/Page)
Signal Mute
Paging Control (with customizable routing)
Amplifier Gain
Bridge Mode
Protection Status
Output Current
Heat Sink Temperature (with Over-Temp.)
Clipping Detect
Output Open
Output Level Meter