Table of Contents
Advertisement
SECTION 8: TROUBLESHOOTING
Problem
Cause
Remedy
Engine fails to start
1.
Fuel tank empty, or stale fuel.
1.
Engine runs erratic
Loss of power
Excessive vibration
Unit fails
to propel itself
Unit fails
to discharge snow
2.
Blocked fuel line.
3.
Choke not in the ON position
4.
Faulty spark plug.
5.
Safety key not in ignition switch on engine.
6.
Spark plug wire disconnected.
7.
Primer button not being used properly.
8.
Fuel shut-off valve closed (if equipped).
1.
Unit running on CHOKE.
2.
Blocked fuel line or stale fuel.
3.
Water or dirt in the fuel system.
1.
Spark plug wire loose.
2.
Gas cap vent hole plugged.
1.
Loose parts or damaged auger.
1.
Drive control cable in need of adjustment.
2.
Drive belt loose or damaged.
1.
Chute assembly clogged.
2.
Shear bolt sheared.
3.
Foreign object lodged in auger.
4.
Auger control cable in need of adjustment.
5.
Auger belt loose or damaged.
6.
Shear bolt(s) sheared.
Fill tank with clean, fresh gasoline. Fuel
becomes stale after thirty days.
2.
Clean the fuel line.
3.
Move switch to the ON position
4.
Clean, adjust gap or replace.
5.
Insert the key fully into the switch.
6.
Connect spark plug wire.
7.
Refer to the engine manual.
8.
Open fuel shut-off valve.
1.
Move the choke lever to OFF position.
2.
Clean the fuel line; fill the tank with clean,
fresh gasoline.
3.
Drain the fuel tank and carburetor. Refill with
fresh fuel.
1.
Connect and tighten spark plug wire.
2.
Remove ice and snow from gas cap. Be
certain vent hole is clear.
1.
Stop the engine immediately and disconnect
the spark plug wire. Tighten all bolts and nuts.
If vibration continues, have the unit serviced
by an authorized service dealer.
1.
Adjust drive control cable. Refer to Making
Adjustment Section.
2.
Replace drive belt. Refer to the Service
Section.
1.
Stop engine and disconnect spark plug wire.
Clean chute and inside of auger housing with
clean-out tool or a stick.
2.
Replace shear bolt.
3.
Stop engine immediately and disconnect
spark plug wire. Remove object from auger.
4.
Adjust auger control cable. Refer to the
Making Adjustments Section.
5.
Refer to Service Section.
6.
Replace shear bolt(s).
16
Advertisement
Table of Contents
