Weider Pro power Stack 831.159832 User Manual page 22

57. Remove the 3/8" Nylon Jamnut (92) used in step
53. Route the Press Cable (72) through the Press
Frame (17).
Wrap the Press Cable (72) around a 3 1/2" Pulley
(35) in the direction shown. Slide a Cable Trap
(38) and the Pulley onto the 3/8" x 4 3/4" Bolt
(102) in the bottom of the Press Upright (5).
Properly tighten the 3/8" Nylon Jamnut (92) onto
the Bolt. Make sure the Cable Trap is posi-
tioned to hold the Cable in the groove of the
Pulley.
58. Wrap the Press Cable (72) around a 3 1/2" Pulley
(35) in the direction shown. Slide a Cable Trap
(38) and the Pulley onto the 3/8" x 4" Carriage
Bolt (112) in the Press Base (3). Secure the Pulley
with a 3/8" Nylon Jamnut (92). Make sure the
Cable Trap is positioned to hold the Cable in
the groove of the Pulley.
59. Lay the Press Cable (72) in the bracket on the
Center Base (2). Attach a 3 1/2" Pulley (35) inside
the bracket with a 3/8" x 1 3/4" Bolt (94) and a
3/8" Nylon Jamnut (92).
60. Wrap the Press Cable (72) around a 4 1/2" Pulley
(36) in the direction shown. Attach the Pulley
inside the indicated bracket on the Center Top
Frame (8) with a 3/8" x 1 3/4" Bolt (94) and a 3/8"
Nylon Locknut (90).
57
5 102
17
58 '.
.-.-.....J _ _.%.'_"
---9
i
\_._ i 72 92
M _ I i '
71 ,q 4
_jJ _l
59 '
_._-_.. -_-..
\ ',\
35i
94
v
_92
72
,36
92
35
22