Troy-Bilt AST TB75SS Operator's Manual page 13

.
4.
Pull old line out of the line loading and line locking
holes (Fig. 16 and 17).
Insert a piece of trimming line straight into one of the
two eyelets in the outer spool. Push it up through the
line loading hole in the inner reel (Fig. 16). Do not
bend the line when inserting it into the eyelet.
7.
8.
Repeat procedures 4-6 with the second piece of line.
Hold the outer spool. Wind the inner reel
counterclockwise until approximately four (4) inches
(102 mm) of line remain (Fig. 19).
NOTE: Do not wind the inner reel before installing the
second piece of line.
.
Trimming Line
Eyelet
Line Loading Hole
Fig. 16
Insert the line into the locking hole (Fig. 17). Do not
push the line more than a 1/2 inch (12.7 mm) into the
line locking hole. The line will form a small loop
(Fig. 17) when it is inserted correctly.
g.
Fig. 19
If winding the line becomes difficult or if the line
jams, pull the ends of the line from the spool
(Fig. 20). Continue winding the inner reel
counterclockwise.
.
Line Locking Hole
Fig. 17
Pull the line from the outer spool until the line is tight
against the inner reel (Fig. 18).
Fig. 2O
INSTALLING A PRE-WOUND REEL
1. Turn the bump knob counterclockwise and remove
the bump knob, spring and foam seal (Fig. 21).
Bump Knob _ _
Foam Seal _
Spring _
Fig. 18
Fig. 21
13