Setting Up Your Tv; Changing The On-Screen Display Language; Selecting The Antenna Input; Using The Ant/Video Button - Toshiba CX32H60 Owner's Manual

Setting up your TV
After you've installed the batteries and programmed the remote
control, you need to set some preferences on the TV using the menu.
You can access the menu with the buttons on your TV or by using the
remote
control,
• When you make a menu selection, your changes occur immediately.
You do not have to press MENU or EXIT to see your changes.
° After fifteen seconds, the menu screen will automatically disappear if
you do not make a selection. Your changes will still be saved.
• When you are finished programming the menus, press EXIT.
Changing the on-screen display language
You can choose from three different languages (English, French and
Spanish) for the on-screen displays. Adjustment menus and messages
will appear in the language of your choice.
_Ib select a language:
1. Press MENU, then press < or • until the SET UP menu appears.
LP 6TO_ ._klO[O IKk_v_III_IP_FE R ,C.C_PT_
LANGUAGE ENGLISH
TViCABLE TV
3H PROGRAM START [< P_
_DD/ERASE ADD
_NTI/2 ANT1
rMORE
SELECT
Pl_ t AUE.0 TIII_II_PiREFEB {E.CAPT
__. _ _ FRANCA i S
TV/CABLE
TV
CAN PROGRAMA _IGUr_NTE _4 _]
ANADfBORAADOAJOU
ANTIi2 ANT1
VPLUS
SELECCION 4_
_N {_
2. Press I or • to highlight LANGUAGE.
3. Press _ or • to highlight your desired language.
Selecting the antenna input
You can connect to two different signal sources by choosing the
antenna input (ANT 1 or ANT 2).
To select the antenna input:
1. Press MENU, then use < or • to highlight the SET UP menu.
2. Press • or • to highlight ANT 1/2.
i HcT_ I AUDIO W. _EFEB}g.C_.P'I I
_ANGUAGE ENGLISH
[V/CABLE
TV
_H PROGRAM
START [_ _]
_DDtERASE ADD
_ANTI ANTa
rt_ORE
SELECT
END {EXIT] 4_k
3. Press *Ior • to highlight either ANT 1 or ANT 2, depending on
the antenna terminal you wish to use.
5 U ANTP,II_EO fV_UMEt TONAf_NF:_Lj
0000 0
_ FJITER--_-->--v ---^
I I I I --J
< ), !FIL
Menu
Enter
©®®
@(9@
@®®
C_ RTN
Vo4,4
I
Menu/Enter
Exit
Using the ANT/VIDEO button
_bu can monitor or change the signal source that is connected to the TM
By pressing the ANT/VIDEO button on your'I_, you can select tile
VIDEO 1, VIDEO 2, ColorStream, ANT 1 or ANT 2 mode. The signal
source you are currently connected to will be displayed in purple.
12