Playing A Disc - Toshiba HD-A2KU Owner's Manual

Connect the player to your TV.
HDMI stands for High Definition Multimedia Interface. HDMI transfers digital audio and uncompressed digital
video on a single cable. As a result, audio cables and video cables don't need to be connected separately to a
device.
The HDMI OUTPUT jack is designed to HDMI Version 1.2a.
HDMI INPUT
Depending on the equipment
connected to this player, such
as a TV or a projector, no sound
may be output by the display.
In this case, set "Digital Output HDMr'
( _ page 53) to "PCM". If sound sti_
is not heard, use analog output.
}
I I To HDMI OUTPUT
HDMI cable (not supplied)
i
Finally connect the supplied
power cord to a wall outlet.
If you use both the HDMI OUTPUT jack and the COMPONENT OUTPUT jacks simultaneouly, video output from the
player to the TV connected via the COMPONENT OUTPUT jacks may be cut depending on the disc.
[HDMil the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.1
ii_!iiiiiiiiiiiii
Notes
• Refer to the owner's manual for the TV to be connected to this player for more information concerning HDMI
connections.
• When the HDMI connection is not verified, the error message appears on the front panel display. In this case,
disconnect the HDMI cable then connect it again, or turn off the connected HDMI device then turn it on.
• HDMI output is digital only, DVI analog is not supported.
• HDMI is an evolving technology, so it is possible that some devices may not operate properly with this player.
• Be sure to use an HDMI cable with the HDMI logo (H-"lrrlli ") to connect an HDMI device.
• If your display does not support multi-channel audio, to use multi-channel audio you will need to either use an AV
receiver that supports multi-channel audio over HDMI (set "Digital Output HDMI" to "Auto" or to match the decoding
capability of your equipment) or use a receiver that has an optical SPDIF digital audio input (set "Digital Output
SPDIF" to match the decoding capability of your equipment).
• If you use also the ANALOG AUDIO OUTPUT jacks or the DIGITAL AUDIO OUTPUT BITSTREAM/PCM jack to obtain
sounds, the output level from these jacks will be reduced when playing a disc recorded in multi channel while setting
"Digital Output HDMI" ( _ page 53) to "Auto" or "PCM". In this case, the output level will be restored by setting to
"Downmixed PCM".
21