Installation - Heath Zenith SL-9525 User Manual

INSTALLATION

For easy installation, select an existing light with a wall
switch for replacement.
❒ Drill out the holes if
needed to mount the
backplate to the junc-
tion box.
Wall Mount
For under eave installation, the sensor head must be
rotated as shown in the next two steps for proper opera-
tion and to avoid the risk of electrical shock. Also for
proper under eave operation, remove the protective
backing from the Light Shield and stick on as shown below.
For eave mount only:
❒ Swing the sensor head towards the clamp screw
joint.
Clamp Screw
❒ Then rotate the sensor head clockwise 180° so
the controls face down.
Light Shield
Opening
If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.
W L
IRE THE
❒ Turn power off at the fuse or circuit breaker.
❒ Remove the existing light fixture.
❒ Route the Light Control's wires through the large
gasket hole.
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8
Eave Mount
Controls
Controls
Controls
C .
IGHT ONTROL
❒ Twist the junction box wires and fixture wires together
as shown. Secure with wire connectors.
Gasket
Black to
Black
Junction box ground wire to
green ground screw on fixture.
M
OUNT THE
❒ Align the Light Control cover plate and cover plate
gasket. Secure with the screws provided.
❒ Align the three slots in the decorative shell with the
lamp holder pins. Push the shell in and then twist
clockwise to lock. Repeat for other shell.
Shell Slot
❒ If a wet location junction box was not used, caulk the
wall plate mounting surface with silicone weather
sealant.
Lock Nut
Lens
❒ Adjust the lamp holders by loosening the lock nuts
but do not rotate the lamp holders more than 180°
from the factory setting. When screwing in the
floodlamps, do not overtighten.
2
White to
White
L C .
IGHT ONTROL
To avoid water damage and
electrical shock, keep lamp
holders 30° below horizontal.
Keep lamps at least
1" (2.5 cm) from the
sensor. Do not allow
the lamps to block
the lens.
595-5612-08