Tools And Supplies Needed; Fireplace System Requirements; Inspect Fireplace And Components - Heat & Glo LifeStyle BAY-40 Owner's Manual

F. Tools and Supplies Needed
Before beginning the installation be sure the following
tools and building supplies are available:
Reciprocating saw
Pliers
Hammer
Phillips screwdriver
Flat blade screwdriver
Plumb line
Level
1/2-3/4 in. length, #6 or #8 self-drilling screws
Misc. screws and nails
G. Fireplace System Requirements
This fi replace system requires:
• Fireplace
• Hearth Refractory
• Grate Assembly
• Hearth Extension (required, sold separately)
• Outside Air Kit
- Duct (required for outside air installation, sold
separately)
• Chimney System (required, sold separately)
• Termination Cap (required, sold separately)
Framing material
Non-combustible sealant
Gloves
Framing square
Electric drill and bits
Safety glasses
Tape measure
Heat & Glo • BAY-40, PIER-40 • 34977 • Rev V • 11/08
H. Inspect Fireplace and Components
WARNING! Risk of Fire and/or Explosion! Damaged
parts could impair safe operation. DO NOT install dam-
aged, incomplete or substitute components. Keep fi re-
place dry.
• Remove fi replace and components from packaging and
inspect for damage.
• Vent system components and doors are shipped in
separate packages.
• Report to your dealer any parts damaged in shipment.
• Read all the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety
and benefi t.
17