7
Electrical Information
A. Recommendation for Wire
This appliance requires 110-120 VAC be wired to the
junction box for proper operation of the appliance.
CAUTION
Label all wires prior to disconnection when servicing con-
trols. Wiring errors can cause improper and dangerous op-
eration. Verify proper operation after servicing.
CAUTION
Shock hazard.
• Replace damaged wire with type 105
rated wire.
• Wire must have high temperature insulation.
NOTE: This appliance must be electrically wired and
grounded in accordance with local codes or, in the absence
of local codes, with National Electric Code ANSI/NFPA 70-
latest edition or the Canadian Electric Code, CSA C221.1.
NOTE: Waterproof insulated wire should be used when
wiring the junction box.
14
O
C
Heat & Glo LifeStyle Collection • Twilight-II • 2087-900 Rev. G • 12/05
B.
Connecting to the Appliance
WARNING
Wire 110V to electrical junction box.
Do NOT wire 110V to valve.
Do NOT wire 110V to wall switch.
•
Incorrect wiring will damage millivolt valves.
•
Incorrect wiring will override IPI safety
lockout and may cause explosion.
• This appliance may be used with a wall switch, wall
mounted thermostat and/or a remote control.
• If using thermostat use one compatible with a millivolt
gas valve system.
• Follow parameters for locating thermostat (see individual
thermostat instructions) to ensure proper operation of
appliance.
• Keep wire lengths short as possible by removing any
excess wire length.
• Low voltage and 110 VAC voltage cannot be shared within
the same wall box.