Advertisement
4.Remove the screw C and spacer in the lower
guard.
5,Slide slotted end of lower guard mounting
bracket under screw head and rotate lower
guard mounting bracket until hole in bracket
lines up with threaded hole ;n upper guard.
Threaded Hole
Mounting Bracket
Slotted
& Spacer
6.Replace'
screw
B, that was removed
in step 3.
Tighten
screw
A and screw B.
7. Replace
screw
C and spacer,
that were
removed
in step 4. Tighten
the screw
C and
spacer
through
the slot.
NOTE: With the blade
guard attached,
the guard
should
raise as the blade is lowered towards
the work table and drop to cover the blade as
the power head is raised.
\
Screw
B
IIIIIIIIIIIIH
II
III
IIIIIII
-
BLADE SQUARE
TO TABLE
NOTE: The miter
saw was assembled
aligned
and
inspected
before
shipment.
Alignment
should
be
checked
and
any
adjustments
made
to
insure
accurate cuts,
!. Check miter
lock handle
setting.
The miter
lock
handle
should be at the 0° position, To reset the
miter
angle, turn the miter
lock-handle
counter
clockwise and press down the index spring.
2 Lower the blade
and lock the handle latch, Use
the combination
square
to check blade
square-
ness to table, If the blade does not contact the
full
length of the square,
follow
the alignment
procedure.
a, Loosen the bevel
lock handle.
b. Grasp
the metal
upper guard
and move the
cutting head to the left as far as it will go,
10
Advertisement
