Pioneer CT-W770 Operating Instructions Manual page 9

FRONT PANEL FACILITIES
I REVERSE MODE SWITCH (REV MODE)
There are three settings:
One way mode = position
When the switch is set to this position, playback or recording is
performed on one side of the tape only. When the tape reaches
the end of the side, it stops automatically (auto stop function).
Two way n_'de _ position
When the switch is set to this position, playback or recording can
be performed on both sides of the tape. When the tape reaches
the end of the first (forward) side, its direction is automatically
reversed, and playback or recording continues on the other
(reverse) side. When it reaches the end of the reverse side, the
tape stops automatically (auto stop function), if playback or re-
cording is started from the reverse side, the tape will stop when it
reaches the end of that side.
Repeat mode _ position (RELAY/SKIP)
When the switch is set to this position for playback, both sides of
the tape are played back repeatedly until the stop (11) button is
pressed, or until the tape has been repeated 15 times (16 sides). If
the pause button is pressed to pause the tape, and then playback
is restarted, the repeat mode starts over from the beginning, and
will repeat the tape 15 times (sixteen sides).
When the switch is set to this position for recording, both sides
are recorded and then the tape stops, as described above for the
two way mode.
NOTE:
If Deck I and II are loaded with tapes, each tape will be played
using relay playback.
Rewind autoplay engaged when the REWIND AUTO PLAY button
is pressed.
Playback starts automatically when the tape is rewound com-
pletely.
FUNCTION DISPLAY
OPERATION OF DECK I WITH A REMOTE
CONTROL UNIT NOT DESIGNED FOR
DOUBLE DECKS (System remote control)
Selecting DECK I
In order to operate DECK I with the remote control unit, adjust the
unit as follows: With the power off, press and hold the stop (11)
button of DECK I, and turn the power on. Continue to hold the stop
(11) button for approximately five seconds. DECK I can now be
operated using the remote control unit, but DECK II cannot.
.... -,..
Switching to DECK II
To restore remote control operation to DECK II, press the stop (11)
button of DECK II while DECK II is in stop mode. DECK II can now
be operated using the remote control unit. Remote control oper-
ation can be switched back and forth between decks by pressing
the stop button of the desired DECK while it is in stop mode.
NO TE:
Ifa power failure or a sudden change in the power supply (caused
by lightning, etc.) occurs, the unit is reset to its original state. Only
DECK II can be operated by remote control. To restore operation to
either deck, repeat the above procedure from the beginning.
,
"" ""1 o ,-.-.-.-.o-,o-.-..o+3 I .. ,,
(D DECK I counter indicator
Normally the tape counter or time counter is displayed (see
page 9). It flashes for 4 seconds after the power cord is con-
nected to the power supply.
DOLBY NR B/C indicator
(_) Level meter
Holds peak for about 1.3 seconds.
The "e" mark beside the 0 dB mark indicates the Dolby NR sys-
tem's standard level.
8
• <RRB1150>
(_) DECK I tape transport mode indicators
• See page 9.
(_) Synchro copy indicator (COPY)
indicator lights steadily: Copying at normal speed.
indicator flashes: Copying at twice normal speed.
(_) DECK II counter indicator -
Normally the tape counter or time counter is _displayed (see
page 9). It flashes for 4 seconds after the power cord is con-
nected to the power supply.
(_) DECK II tape transport mode indicators
• See page 9.