Table of Contents
Advertisement
Most treadmill
problems
can be solved by following
the steps below. Find the symptom
that applies, and
follow the steps listed, mffurther assistance
is needed, please call our Customer
Service Department
toll-
free at 1-888-825-2588,
Monday through
Fdday, 8 a.m. until 6 p.m. Mountain
Time (excluding
holidays}.
PROBLEM:
The power does not turn on
SOLUTmON: a, Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 9), Use only a single-outlet surge suppressor
that meets all of the specifications described on page 9, important: The treadmill is not compatible
with GFCl-equipped
outlets,
b, After the power cord has been plugged in, make sure that the key is fully inserted into the console,
C,
Check the reset/off circuit breaker located on the
treadmill frame near the power cord, if the switch pro-
trudes as shown, the circuit breaker has tripped To
reset the circuit breaker, wait for five minutes and
then press the switch to the reset position,
Tripped
Reset
PROBLEM:
The power turns off during
use
SOLUTION:
a, Check the reset/off circuit breaker (see the drawing above), if the circuit breaker has tripped, wait
for five minutes and then press the switch to the reset position,
b, Make sure that the power cord is plugged in, if the power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in,
c, Remove the key from the console, Reinsert the key fully into the console,
d, if the treadmill still wiii not run, please caii our Customer Service Department, toll-free,
PROBLEM:
The disptays
of the consote do not function
properly
SOLUTION:
a, Remove the key from the console and unplug the
power cord. Carefully tip the Uprights (69) down as
shown in drawing a, Remove the two Front Belly Pan
Screws (3) and the two Screws (83) from the Hood
(23); remember which hoJe each Screw was re-
moved from. Raise the Uprights back to the vertical
position and carefully remove the Hood,
Locate the Reed Switch (10) and the Magnet (7) on
the left side of the Pulley (8), Turn the Pulley until the
Magnet is aligned with the Reed Switch, Make sure
that the gap between the Magnet and the Reed
Switch
is about 1/8". if necessary, loosen the Screw
(27) and move the Reed Switch slightly, Retighten the
Screw, Reattach the Hood (23), making sure that the
Screws (3, 83) are inserted into the same hobs from
which they were removed, Run the treadmill for a few
minutes to check for a correct speed reading,
27
Advertisement
Table of Contents
