Table of Contents
Advertisement
MAINTENANCE
M
O
W
E
R
MAINTENANCECHART
PROCEDURE
Blade Rotation Control, Check
RRST
EACH
2
USE
HOURS
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
EVERY
EVERY
EVERY
25
50
100
BEFORE
HOURS
HOURS
HOURS
STORAGE
¢
Motion Drive Belt, Check
¢
Battery, Check and Charge
¢
¢
GENERAL RECOMMENDATIONS
1.
The owner's responsibility is to maintain this product. This will
extend the life ofthe product end is also necessary to maintain
warranty coverage.
2.
Check the sperk plug, drive brake, lubricate the unit, and clean
the air filter once a year.
3.
Check the fasteners. Make sure all fasteners are tight.
4.
Followthe Maintenance section to keep the unit in good operat-
ing condition.
WARNING: Before you make an Inspection, edjuet-
A
ment, or repair to the unit, disconnect the wire to the
spark plug. Remove the wire from the spark plug to
prevent the engine from starting by accident.
NOTE: Torque is measured in foot pounds (metric Nm). This
measurement
describes
how tight a nut or bolt must be. The
torque is measured with a torque wrench.
HOW TO CHECK THE MUFFLER
Check the muffler every 50 hours. Make sure the muffler is correctly
mounted and is not loose. If the muffler is worn or burnt, replace with
a new muffler. A worn muffler is a fire hazard and can also damage
the engine.
If you mount a spark arrester to the muffler, also check the spark
arrester when you check the muffler. If the spark arrester is worn or
damaged, replace it with e new spark arrester. See your nearest
authorized service center for e spark arrester.
F- 98893
21
Advertisement
Table of Contents
