Table of Contents
Advertisement
OPERATION
OPERATING TIPS
1,
Check the blade rotation control for correct adjustment. For the
blade(s) to disengage correctly, the adjustment must be cor-
rect.
5.
2.
Before you use the unit, check the oil in the engine and add oil
6.
if necessary.
3.
If the engine will not start, first make sure the wire is attached
to the spark plug.
7.
4.
Make sure all the belts are inside all the belt guides. See the in-
structions on how to remove and install the motion drive and
8.
mower drive belts.
Before you make an inspection, adjustment (except for the car-
buretor) or repair, make sure the wire from the spark plug is dis-
connected.
For _onger life ofthe battery on electric start models, charge the
battery every three months.
Use the speed control pedal to change the ground speed, not
the throttle control.
Belt noisecan occurwhen the blade isengaged.This noiseis
normaland does not affectthe operationofthe unit.
MOWING
AND BAGGING
TIPS
1.
For a lawn to look better, check the cutting level of the mower
housing. See =How To Level The Mower Housing" in the Main-
tenance section.
2.
3.
4.
5.
6.
7.
8.
9.
For the mower housing to cut level, make sure the tires have
the correct amount of air pressure.
Every time you use the unit, check the blade. If the blade is bent
or damaged, immediately replace the blade. Also, make sure
the nut for the blade is tight.
Keepthe blade(s)sharpened.Wornbladeswillcausethe ends
ofthe grassto turnbrown.
Do not cut or bag g rass that is wet. Wet grass will notdischarge
correctly. Let the grass dry before cutting.
Use the left side of the mower housing to trim near an object.
Discharge the cut grass onto the mowed area. The result Is a
more even discharge of cut grass.
When you mow large areas, start by turning to the right so that
the cut grass will discharge away from shrubs, fences, drive-
ways, etc. After one or two rounds, mow in the opposite direc-
tion making left turns until finished (Figure 13).
Ifthe grass is very high, cut two times to decrease the load on
the engine. Firstcut with the mower housing inthe highest posi-
tion and then lower the mower housing for the second cut.
10.
11.
12,
13,
For better engine performance and an even discharge of the
cut grass, always operate the engine with the throttle in FAST
position.
When you use a bagger, operate the engine with the throttle in
FAST position and the speed control pedal pushed 1/3 forward.
For better cutting performance and a quality cut, mow with the
speed control pedal pushed 1/3 to 1/2 forward.
After each use, clean the bottom and top of the mower housing
for better performance. Also, a clean mower housing will help
prevent a fire.
<
J
Figure13
F- 98893
19
Advertisement
Table of Contents
