Table of Contents
Advertisement
SECTION 5: OPERATING Y OUR LAWNMOWER
Towards BetterMowerPerformance
1.
Pour fresh, clean gasoline into the mower's gas
tank until the tank is full. Do not use gasoline
that is more than 30 days old.
2.
Always use a fuel stabilizer. It will double the life
of the gasoline used.
3.
Make sure to connect the mower's spark plug
wire before trying to start the engine.
4.
Add engine oil to the oil fill on the mower engine.
Check the dipstick and add more if necessary.
Remember that the oil level has to touch the fill
line.
5.
Locate the primer decal near the primer bulb on
the engine, and read its instruction. Using your
thumb, press the primer bulb slowly as many
times as the decal advises.
WARNING:
Keep hands
and feet away
from chute area on the cutting deck. The
operation of any lawn mower can result in
foreign
objects
being thrown
into the
eyes,
which
can
result
in severe
eye
damage. Always wear safety glasses or
eye shields.
NOTE: For shipping purposes your mower is set with
the wheels in a low cutting height position. For best
results raise the cutting position until it is determine
which height is best for your lawn. See the Adjustment
Section for details.
GasandOilFill-Up
Service the engine with gasoline and oil as instructed in
the separate engine manual packed with your mower.
Read instructions carefully.
WARNING: Never fill fuel tank indoors with
engine
running or until the engine has
been allowed
to cool
for at least two
minutes after running.
Starting Engine
Attach spark plug wire to spark plug. Make certain
the metal cap on the end of the spark plug is
fastened securely over the metal tip on the spark
plug.
Prime engine as instructed in the separate engine
manual packed with your unit.
Your lawn mower is equipped with a constant
speed throttle, which is set at full throttle for best
performance.
6.
Hold control handle down and pull rope firmly to
start the engine.
7.
Set cutting height adjustment lever to middle
setting and mow a single pass on your lawn;
then adjust to desired height for a closer cut.
8.
To mulch insert the mulch plug/cover on the
mower.
9.
In heavy growing season, it may be necessary
to mow lawn twice weekly. Clumps of grass
clippings left behind on the lawn usually means
that the grass is too high to mulch.
10. Before storing the lawn mower for the winter,
use stabilizer-treated
fuel and run the tank dry.
11. Thirty days before start of the new season,
check the air filter, spark plug and blade on the
lawn mower, and replace if needed.
Stand behind the mower and squeeze the blade
control handle against the upper handle.
Grasp recoil starter handle and pull rope out slowly
until engine reaches the start of compression cycle
(rope will pull slightly harder at this point).
Pull rope with a rapid, continuous, full arm stroke.
Keeping a firm gdp on the starter handle and let the
rope rewind slowly.
Repeat the previous steps until engine fires.
Using Your LawnMower
Be sure that the lawn is clear of stones, sticks, wire, or
other objects which could damage the lawn mower or
the engine. Such objects could be accidently thrown by
the mower in any direction and cause serious personal
injury to the operator and others.
For best results, do not cut wet grass because it tends
to stick to the underside of the mower, preventing
proper discharge of grass clippings, and could cause
you to slip and fall. New grass, thick grass, or wet grass
may require a narrower cut.
For a healthier lawn, never cut off more than one-third
of the total length of the grass. Your lawn should be cut
in the fall as long as there is growth. This mower is
designed to be operated at full throttle to give you the
best cut and do the most effective job of mowing or
mulching.
Advertisement
Table of Contents
