Fisher & Paykel OR24SDPWGX User Manual page 19

PROBLEMS ON STARTING AND DURING THE SELF CLEANING
1.
door
Steady
The function selector has been turned to the self cleaning position with the oven
door open or not perfectly closed. Or the door has been opened before the cycle
has been started with confirmation from key 3
What to do:
Close the door and repeat previous cycle.
.
If after 5 minutes the door has not been closed
sounds for 30".
What to do:
Close the door, press any programmer key to silence the audible signal and repeat the
operations to start the cycle.
2.
door
with AUTO flashing
The oven door has been opened after the self cleaning cycle has started (before
locking the door). The self cleaning cycle is zeroed.
What to do:
P0•00
1. Close the door.
P AUTO
and flashing.
2. Turn the function selector to
.
If after 5 minutes the door has not been closed
sounds for 30".
What to do:
Close the door, press any programmer key to silence the audible signal and repeat the
operations to start the cycle.
3.
F0.00
with AUTO flashing
The self cleaning cycle has been stopped and then started again when it was quite a
way through. The message is displayed after about 10 minutes and the self cleaning
cycle is zeroed.
What to do:
OFF
1. Put the switch to .
2. Wait for at least 15 minutes.
3. Repeat the operations to start the self cleaning cycle.
4. If after several attempts the message continues contact the Service Centre.
Caution: It is advisable not to stop the self cleaning cycle and then start it again
when it is quite a way through.
door
appears on the electronic programmer display with the letter
OFF
and repeat the operations to start the cycle.
door
flashes and an audible signal
flashes and an audible signal
4
I I I I I I I I I I
I I I I I I I I I I
I I I I I I I I I I
I I I I I I I I I I
19