Troubleshooting - Craftsman Incredi-Pull 316.791880 Operator's Manual

CAUSE
1. Empty fueHtank
2. Primer buHbwasn't pressed enough
3. Engine is flooded
4. OHdor improperly mixed fueH
5, FouHed spark pHug
6. Mugged spark arrestor
7. Red EZ-Fke
TM
Heverwasn't flipped/set
8, The outside temperature is bellow 40 ° F
9. The outside temperature is above 90 ° F
CAUSE
1. Air fiHteris pHugged
2. OM or improperly mixed fueH
3. Improper carburetor adjustment
CAUSE
I.OHd or improperly mixed fueH
2. Improper carburetor adjustment
3. Cutting attachment bound with grass
4. Dirty air fiHter
5. Mugged spark arrestor
CAUSE
I.OHd or improperly mixed fueH
2.AirfiHter ispHugged
3. Improper carburetor adjustment
4. FouHed spark pHug
5. Mugged spark arrestor
ACTION
I.Fill fuel tankwithproperly mixed fuel
2. Press primer bulb fully and slowly 10 times
3. Squeeze the trigger and pull the starter rope
4. Drain gas tank and add fresh fuel mixture
5. Replace or clean the spark plug
6. Clean or replace spark arrestor
7. Move lever to the starting position
8. Pull the starter rope up to 10-15 times
9. Squeeze the throttle control and pull the starter rope
without moving the Red EZ-Fire
TM
lever
ACTION
1. Replace or clean the air filter
2. Drain gas tank and add fresh fuel mixture
3. Adjust according to the Carburetor Adjustments
ACTION
1, Drain gas tank and add fresh fuel mixture
2. Take to a Sears or other qualified service dealer for
3. Stop the engine and clean the cutting attachment
4. Clean or replace the air filter
5. Clean or replace spark arrestor
ACTION
1. Drain gas tank and add fresh fuel mixture
2. Replace or clean air filter
3. Take to a Sears or other qualified service dealer for
an adjustment
4. Replace or clean the spark plug
5. Clean or replace spark arrestor
NOTE: For repairs beyond the minor adjustments listed above, contact your nearest Sears Parts &
®
Repair center (1 800 4 M%HOME ) or other qualified service dealer for an adjustment.
16