Controls And Features - MTD E46M Operator's Manual

Self propelled mower
Table of Contents

Advertisement

Controls a nd Features
4
Drive Controk
Recoil Starter
Electric Start ignition Switch
Control
Side Discharge
Chute
Mulch Pluq
Cutting
Height
Adjustment
Levers
.
/
Figure 4=1
BladeControl
MulchPlug
The blade control
is attached
to the upper handle of the mower.
Depress and squeeze it against the upper handle to operate the
unit. Release it to stop engine and blade.
_
ARNING:
This blade control
is a safety device.
Never attempt
to bypass its operations.
The mulch plug is used for mulching
purposes.
Instead of
collecting
the grass clippings
in a grass catcher or using the
side discharge
chute, some mower models
have the option
of recirculating
the clippings
back to the lawn. This is called
mulching.
SideDischarge Chute
DriveControl
The drive control
is located
on the underside
of the upper handle
and is used to engage the drive. Squeeze it against the upper
handle to engage the drive; release it to slow down or stop
mower from propelling.
ChokeControl
The choke control
is located
on the left side of the handle and
when activated,
closes the choke plate on the carburetor
and
aids in starting
the engine. Pull the choke control
to activate
the
choke on the engine. Use of the choke may not be necessary if
the engine
is warm or the air temperature
is high.
Your mower
is shipped
as a mulcher. To discharge
the grass
clippings
to the side instead, follow
the instructions
in the
Assembly
& Set-Up section
to attach the side discharge
chute.
_hb
ARNING:
Keep hands and feet away from the
chute area on cutting
deck. Refer to warning
label
on the unit.
ElectricStartIgnition Switch
The ignition
switch is located
on the left side of the handle panel.
It is used only for the electric
starter.
Recoil S tarter
Cutting HeightAdjustmentLevers
One adjustment
lever is located
on each wheel and is used to
adjust the cutting
height. All four levers have to be at the same
relative
position
to ensure a uniform
cut.
The recoil starter is attached
to the right upper handle. Stand
behind
the unit and pull the recoil starter rope to start the unit.
11

Advertisement

Table of Contents
loading

Table of Contents