Advertisement
Start with Step 1 to set-up you new chipper shredder.
All models.
n
IStep 1.
Pull the spark plug wire off of the spark plug.
EStep 2.
Remove six hex nuts (A) and six washers (B) from the weld studs on the flail housing.
Leave
the support plate in place on the weld studs.
Step 3,
Place hopper assembly
into position in front of flail housing.
Align holes in hopper
assembly collar with weld studs on flail housing.
Step 4.
Slide hopper assembly onto weld studs.
Step 5.
Replace the washers (B) and the hex nuts (A).
Step 6.
Tighten
the hex nuts (A).
Step 7.
Lift hopper until it clicks into the raised position.
Flail Housing
)
_ark Plug
Wire
Washer
Hex Nut
Weld Stud
Support Plate
Hopper Assembly
)8,
Remove wing knobs (C) from
each side of the discharge
chute opening on the chipper
shredder.
pg.
Use two 7/16" wrenches
to remove
hex lock nut (D). Remove two spacers
(E), and hex bolt
(F) from top of the housing
assembly.
For easy assembly,
do not remove
the second
spacer
from the hex bolt.
10.
Place the discharge
chute
in position on the discharge
opening.
Insert hex bolt (F) and
spacer
(E) through
hinge on discharge
chute
and housing
(spacer
fits inside of hinge).
Step 11
Place second spacer (E) over hex bolt (F) inside the other half of the hinge.
Secure with hex
lock nut (D). Tighten securely,
Step 12.
Secure both sides of discharge
chute to flail housing
using wing knobs (C). Tighten wnng
knobs.
Hinge\
Spacer (E)"
Hex Lock Nut (D)
Hex Bolt (F)
\
\\
Wing Knob(C)
Dischargej
Chute
\
Wi_ng Knob (C)
5
<
/
Advertisement
