Ignition Switch - MTD 660 Operator's Manual

SECTION 4: CONTROLS
A
B
C
I-II-II-II-II-ID
1-11-11-11-1
I-I1-11-113
NNNmm_
NOTE:
Steering Wheel not shown for clarity,
1-11-11-11-11-11-1
E
F
t
If so equipped
Figure 8
A Clutch-brake Pedal
B Choke Controlt
C Throttle Control Lever
D Pto (Blade engage) Lever
E Ignition Switch
F Shift Lever
G Speed Control Lever/Parking Brake
H Seat Adjustment Levert
IgnitionSwitch
The ignition switch is located on the right side of the
tractor's dash.To start the engine, insert the key into the
ignition switch and turn clockwise to the START
position. Release the key into the ON position once
engine has fired. See Figure 9.
Refer to Starting TheEngine on page 13 of this manual for
detailed starting instructions
WARNING:
Never leave a running
machine unattended. Always move the PTO
(blade engage) lever into the disengaged
(BLADES STOP) position, Shift into neutral,
set parking brake, stop engine and remove
key to prevent unintended starting.
STOP
START
Tractor Models
668 & 688 Only
All Tractor Models
Except 668 & 688
Figure 9
11