Gasandoilfill-Up; Tire Pressure; Attaching The Batterycables - MTD 660 Operator's Manual

GasandOilFill-up
The gasoline tank is located under the hood and has a
capacity of 1-1/2 gallons. Do not overfill.
WARNING:
Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoors or while the
engine is hot or running. Extinguish
cigarettes, cigars, pipes, and other sources of
ignition.
Service the engine with gasoline and oil as instructed in
the separate Briggs & Stratton Operator/Owner Manual
(or Tecumseh engine's Owner's Manual) packed with
your tractor. Read instructions carefully.
IMPORTANT: Your tractor is shipped with motor oil in the
engine. However, you MUST check the oil level before
operating. Be careful not to overfill.
Tire Pressure
_, WARNING: Maximum tire pressure under
any circumstances is 30 psi. Equal tire
pressure should be maintained at all times.
The tires on your unit may be over-inflated for shipping
purposes. Reduce the tire pressure before operating
the tractor. Recommended operating tire pressure is
approximately 10 p.s.i for the rear tires & 14 p.s.i, for
the front tires. Check sidewall of tire for maximum p.s.i.
Attaching the BatteryCables
NOTE:
Some models are shipped with the battery
cables already connected.
NOTE:
The positive battery terminal is marked Pos.
(+). The negative battery terminal is marked Neg. (-).
• The positive cable (heavy red wire) is secured to
the positive battery terminal (+) with a hex bolt and
hex nut at the factory. Make certain that the rubber
boot covers the terminal to help protect it from
corrosion.
• Remove the hex bolt and hex nut from the negative
cable.
• Remove the black plastic cover, if present, from the
negative battery terminal and attach the negative
cable (heavy black wire) to the negative battery
terminal (-) with the bolt and hex nut.
• Make certain the hold-down rod is in position over
the battery, securing it in place. See Figure 6.
Rubber
Boot
Hex Bolt
Figure 6
IMPORTANT:If the battery is put into service after the
date shown on top of battery, charge the battery as
instructed on page 24 of this manual prior to operating
the tractor.
Identifyingthe Mulch Plug (if soequipped)
On tractor models with 38- and 42-inch decks so
equipped, a mulch plug can be found within the cutting
deck's discharge opening.
NOTE: Refer to Mulchingon page 15 for more detailed
information.
If you'd prefer to operate the cutting deck without
mulching, simply remove the mulch plug by
unthreading the plastic wing nut which fastens it to the
cutting deck. This will allow the grass clippings to
discharge out of the discharge opening during
operation. See Figure 7.
©
Plastic Wing Nut
Mulch Plug
Figure 7
10