Advertisement
our TV remote can be set to
work your Cable Converter
by
what is called the SEARCH
method.
If the "REMOTE
CODE"
number
method
shown in the previous
section
did not set your remote to
_ork your Co_ verter, then follow
the easy steps listed below.
Please
read through
steps 1-4
before
beginning.
<_
Press the POWER
button
on
I the Converter
to turn Converter
ON.
_
Stand at least six feet away from
the front of the Convener.
Point
the remote
toward the
Convener.
tlOLD
DOWN
the MCtt
and
CBL System
buttons
at the same
time. KEEP HOLDING
BUTFONS
DOWN.
_a
Watch
the Channel
Indicator
on the Converter.
Channel
Numbers
will SCAN
UP
when the Converter
has been
identified.
This may take up to two
minutes.
_'
Release
the, A/CH and CBL
System
buttons
as soon as channel
numbers
start to scan up. The
Converter
code has been identified
and the remote
is ready to operate
the Converler.
_,_
Remember.
A minute
or
two can seem very long, but the
code shoukt be located within two
minutes.
Don't let the Converter
scan up
:more than five channels.
If you do
the remote
may pass up the right
code and another
two minute
search cycle will have to be
repeated.
If no channel
change happens
within two minutes,
repeat steps 1-
4. Should a channel change still
not occur, the remote will not work
with the desired Converter.
Cable Converter
O9
Don'l lel Ibe Com,'er'_er scan
up more than five channels
(in Search mode).
31
Six Feet
(minimum)
Advertisement
