Advertisement
J
See the above information on
how to u_ the Locator Code
Button for Programming.
For most homes
this step would
not be needed
but for your
information:
Up to 9 different remote locator
address codes can be set on which the
TV can send out its "homing" signal.
This is done in case there is more than
one TV (with a remote locator)
present, and you want only one
specific remote to be signaled when the
TV is turned ON.*
To set a Locator Address Code:
<_
With TV turned ON, press the
LOCATOR CODE button on the
remote. (Also be sure the TV
SYSTEM button on the remote has
been pressed.)
You will need a pencil or pen to press
the recessed button.
The TV shows the present Remote
Locator Code.
<
,_
Press any number button (0-9) on
the remote to set or change the Locator
Code.
The remote will beep to let you know
it has received the new Locator Code
and then return to its normal operating
mode.
O
_[_
Remember. If batteries
are
placed the l.,ocator Code#viii
need to be reentered.
When setting the Locator Code if any
button, other than the number buttons,
are pressed the remote will return to its
normal operation mode.
*For owners who live in an apartment
J
(townhouse or condominium)
complex, this task may be necessary
since the remote locator's signal can be
sent and detected direcly through
adjoining walls.
2S
Advertisement
