GE DBVH512 Owner's Manual page 8

About the dryer controlpanel
O Dry Temp
You can chanoe_ the temperature ot your dry cycle.
ANTI-BACTERIAL
(on some models)
Thisoption may only be usedwith COTTONSor MIXED LOADcycles.This optionreducescertain
typesof bacteriaby 99.9%,including:Staphy/ococcus a ureus,Pseuflomonas aeruginosaandK/ebsie//a
pneumoniae*.Theanti-bacterialprocessoccurswhen high heatis usedduringa portionof this
dryingcycle.
NOTE:Donot usethis cycleon delicatefabrics.
TheAnti-BacterialCycleis Certifiedby NSFInternational(formerlyNationalSanitationFoundation)
to NSFProtocolP154SanitizationPerformance of ResidentialClothesDryers.
NSF Protocol P 154 ]
S midzatio_l Perfbrmailce of
Residential (_]othes Dryers
HIGH Forregularto heavycottons.
MEDIUM Forsynthetics,blendsanditems labeledpermanentpress.
LOW Fordelicates,syntheticsanditems labeledTumb/e DryLow.
EXTRALOW Forlingerie andspecial-carefabrics.
NO HEAT Canonlybe usedwith TIMED DRY.
(onsomemodels)
O START
Press to start a (h'_ cycle. If the (h'_er is Hmning press it once and it will pause the dr_er.
Press it again to restart the dry c_cle.
My Cycle (on some models)
Set up your fh\'orite combination of settings and save them here for one touch recall.
These custom settings can be set while a cycle is in progress.
To store a MY CYCLE combination of settings:
I.
Select your drying cycle.
2. Change DRY TEMP _nd SENSOR DRYLEVEL settings to fit your needs.
3. Select any drying OPTIONSw)u want.
4. Press and hold the _ pad for three seconds to store your selection. A beep will sound
and the pad will light up.
To recall your stored MY CYCLE combination:
Press the MYCYCLEbutton
belore drying a load.
To change your stored MY CYCLE combination:
Follow steps 1-4 in "To store a MY CYCLE combination of settings"
@
"CLEAN LINT FILTER" (message)
(This message represents only a reminder.)
After the POWER button is pressed, the "CLEAN LINT FILTER" message could appear if the prexious
c_cle was not finished.
This messaoe,, _ will disappear after the STARTbutton
is pressed.
Exert thouoh you have already cleaned the filter (befi_re
or after the POWER button
has been
pressed), the "CLEAN LINT RLTER'message will still be displa)ed until the SYARYbutton is actixated.
8