GE Monogram ZDBT240 Owner's Manual page 9

Controls and Features
Beverage Center
Glass
shelves
Tempered glass shelves in the beverage
center unit are removable for easg cleaning
or for storing larger items.
To remove a shelf, open the door
completelg to ovoid potential damage to
the gasket. Lift up on the buck of the shelf
slightly. Tilt the shelf to one side at an angle
while pulling forward.
Appearance may vary
To replace a shelf, open the door
completelg to avoid potential damage
to the gasket. Tilt the shelf to one side
at an angle and slide toward the back wail,
placing one side onto the shelf support.
Place the other side onto the opposite
shelf support. Ensure rear locking tabs are
engaged. When installed properly, the shelf
will not slide forward when gently pulled.
To remove, lift up on the back of the shelf Tilt the shelf at an angle while removing
or replacing
Place in slots when replacing the shelf
OuickSpace T.
shelf
This shelf splits in half and slides under itself
for storage of tall items on the shelf below.
Step 1: Lift the back edge of the front half
of the shelf.
Step 2: Pull slightlg forward.
Step :3: Lower the back edge of the front half
of the shelf while sliding it underneath the
back half.
The entire Quick Space shelf can be removed
and replaced (see Glass Shelves section).
Step 1
Step ;
Step 3
Interior fan
The interior fan is located in the rear wall of
the beverage center, and is designed to run
continuouslg to help maintain the proper
cooling temperature. The interior fan will
onlg turn off when the door is opened.