Installation Instructions - GE AHH18DQT1 Owner's Manual And Installation Instructions

I
Installation
Instructions
Air Conditioner
r_ Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com
I
BEFORE YOU BEGIN
Reud these instructions completely
ond corefully.
• IMPORTANT - Sove these instructions
forlocol inspector's use.
• IMPORTANT - Observe oll
governing
codes ond ordinonces.
• Note to Installer- Be sure to leove these
instructions with the Consumer.
• Note to Consumer - Keep these instructions for
future reference.
• Skill level - Instollotion of this opplionce requires
bosic mechonicol skills.
• Completion time - Approximotely 1 hour
• We recommend thor two people instoll
this product.
• Proper instollotion is the responsibility
of the instoller.
Product foilure due to improper instollotion is not
covered under the Worronty.
You MUST use oil supplied ports ond use proper
instollotion procedures os described in these
instructions when instolling this oir conditioner.
(_ ELECTRICAL REQUIREMENTS
Some models require o 115/120-volt AC,
(_ 0-Hz grounded outlet protected with o
15-omp time-deloy fuse or circuit breoker.
The 3-prong grounding plug minimizes the
possibility of electric shock hozord. If the woll outlet
you Non to use is only o 2-prong outlet, it is your
responsibility to hove it reploced with o properly
grounded 3-prong woll outlet.
©
Some models require 230/208-volt AC,
protected with o time-deloy fuse or circuit
breoker. These models should be instolled on
their own single bronch circuit for best
performonce ond to prevent overlooding
house or oportment wiring circuits, which
could couse o possible fire hozord from
overheoting wires.
-&CAUTION:
Do not, under ony circumstonces, cut or remove
the third (ground) prong from the power cord.
Do not chonge the plug on the power cord
of this oir conditioner.
Aluminum house wiring moy present speciol
problems-consult o quolified electricion.
TOOLS YOU WILL NEED
Phillips head screwdriver
Drill with 1/8" bit
Flat-blade screwdriver
Adjustable Wrench
Pencil
Ruler ortapemeasure
Level
Scissors or knife
Power cord includes o current interrupter device. A
test ond reset button is provided on the plug cose. The
device should be tested on o periodic bosis by first
pressing the TESTbutton ond then the RESETbutton
while plugged into the outlet. If the TEST button does
not trip or if the RESETbutton will not stoy engoged,
discontinue use of the oir conditioner ond contoct o
quolified service technicion.