Using Network Function; Example Of Network Connection; Command Control - Panasonic TH-58PF12WK Operating Instructions Manual

Using Network Function

This unit has a network function to control the network connected display with your computer.
Note:
To use the network function, set each "Network Setup" setting and make sure to set the "Control I/F Select" to "LAN".
(see page 51)
When "LAN" is set, power indicator is lit orange when the slot power is turned on, then the power is turned "Off" with
remote control (stand-by state) regardless of the "Slot power" setting. (see page 54)

Example of Network Connection

COMPUTER
Ferrite core
(supplied)
Hub or broadband router
Notes:
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• To connect a device using 100BASE-TX, use "category 5" LAN cable.
• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
• For instructions on how to connect, consult your network administrator.

Command Control

Network function of the unit can control the unit in the same way as serial control from a network.
Supported commands
Commands used in the serial control are supported. (see page 10)
Note:
Consult your local Panasonic dealer for detail instructions on command usage.
Less
than
10 cm
LAN cable
(not supplied)
Ferrite core
(supplied)
Installing the Ferrite core
Less
than
10 cm
Pull back the tabs
(in two places)
Display (main unit, rear)
AUDIO P /C /R P /C /B Y/G
R R B B
LAN COMPONENT/RGB IN
SLOT3
Wind the cable
twice
Open
Press the cable
through and close
57