Basic Maintenance - Milwaukee 2217-20 Repair Service Instructions

Basic Maintenance

To avoid shock, disconnect test leads from any voltage source than remove from meter before
opening the case or replacing the battery.
Opening the Battery Door
To avoid unintentional shock circuit, always place the uncovered Meter assembly on a protective
surface. When the case of the Meter is open, circuit connections are exposed.
To open the Battery Door, do the following:
1. Disconnect test leads from any voltage source, turn rotary switch to OFF, and remove the test
leads from meter before opening the case.
2. The battery door is secured to the case top by three screws. Using a Phillips-head screwdriver,
turn the screws counter-clockwise to remove.
Replacing the Battery
The meter is powered by 2 AA 1.5V batteries.
To replace the battery refer to figure.
WARNING
CAUTION
11