Basic Maintenance - Milwaukee 2206-20 Repair Service Instructions

Basic Maintenance

To avoid shock, disconnect test leads from any voltage source than remove from meter before
opening the case or replacing the battery.
Opening the Meter Case
To avoid unintentional shock circuit, always place the uncovered Meter assembly on a protective
surface. When the case of the Meter is open, circuit connections are exposed.
To open the Meter case, do the following:
1. Disconnect test leads from any voltage source than remove from meter before opening the case.
2. Remove the battery door by using a flat-blade screwdriver to turn the battery door screws
counter-clockwise.
3. The case bottom is secured to the case top by two screws. Using a Phillips-head screwdriver,
remove the two screws.
Replacing the Battery
The meter is powered by 2 AA 1.5V batteries.
To replace the battery refer to figure.
WARNING
CAUTION
10